1. University of Chinese Academy of Sciences, Beijing 101408, China; Technical Institute of Physics and Chemistry, Chinese Academy of Sciences, Beijing 100190, China 2. Technical Institute of Physics and Chemistry, Chinese Academy of Sciences, Beijing 100190, China
Bi-directional turbines combined with rotary motors may be a feasible option for developing high power thermoacoustic generators with low cost. A general expression for the acoustic characteristics of the bi-directional turbine was proposed based on theoretical derivation, which was validated by computational fluid dynamics modeling of an impulse turbine with fixed guide vanes. The structure of the turbine was optimized primarily using steady flow with an efficiency of near 70% (the shaft power divided by the total energy consumed by the turbine). The turbine in the oscillating flow was treated in a lumped-parameter model to extract the acoustic impedance characteristics from the simulation results. The key acoustic impedance characteristic of the turbine was the resistance and inertance due to complex flow condition in the turbine, whereas the capacitance was treated as an adiabatic case because of the large-scale flow channel relative to the heat penetration depth. Correlations for the impedance were obtained from both theoretical predictions and numerical fittings. The good fit of the correlations shows that these characteristics are valid for describing the bi-directional turbine, providing the basis for optimization of the coupling between the thermoacoustic engine and the turbine using quasi-one-dimensional theory in the frequency domain.
W Dai, G Yu, S Zhu, E Luo. 300 Hz thermoacoustically driven pulse tube cooler for temperature below 100 K. Applied Physics Letters, 2007, 90(2): 024104 https://doi.org/10.1063/1.2405882
2
L M Zhang, J Y Hu, Z H Wu, E C Luo, J Y Xu, T J Bi. A 1 kW-class multi-stage heat-driven thermoacoustic cryocooler system operating at liquefied natural gas temperature range. Applied Physics Letters, 2015, 107(3): 033905 https://doi.org/10.1063/1.4927428
3
S, Backhaus E Tward, M Petach. Traveling-wave thermoacoustic electric generator. Applied Physics Letters, 2004, 85(6):1085–1087 https://doi.org/10.1063/1.1781739
4
Z Wu, L Zhang, W Dai, E Luo. Investigation on a 1 kW traveling-wave thermoacoustic electrical generator. Applied Energy, 2014, 124(1): 140–147 https://doi.org/10.1016/j.apenergy.2014.02.063
5
T Bi, Z Wu, L Zhang, G Yu, E Luo, W Dai. Development of a 5 kW traveling-wave thermoacoustic electric generator. Applied Energy, 2017, 185(2): 1355–1361 https://doi.org/10.1016/j.apenergy.2015.12.034
6
T Jin, J L Huang, Y Feng , R Yang, K Tang, R Radebaugh. Thermoacoustic prime movers and refrigerators: thermally powered engines without moving components. Energy, 2015, 93(2): 828–853 https://doi.org/10.1016/j.energy.2015.09.005
7
A Hamood, A J Jaworski, X Mao. Development and assessment of two-stage thermoacoustic electricity generator. Energies, 2019, 12(9): 1790 https://doi.org/10.3390/en12091790
8
G Yu, X Wang, W Dai, E Luo. Study on energy conversion characteristics of a high frequency standing-wave thermoacoustic heat engine. Applied Energy, 2013, 111: 1147–1151 https://doi.org/10.1016/j.apenergy.2012.09.050
9
M A G Timmer, K de Blok, T H van der Meer. Review on the conversion of thermoacoustic power into electricity. Journal of the Acoustical Society of America, 2018, 143(2): 841–857 https://doi.org/10.1121/1.5023395
10
A A Castrejón-Pita, G Huelsz. Heat-to-electricity thermoacoustic-magnetohydrodynamic conversion. Applied Physics Letters, 2006, 90(17): 174110 https://doi.org/10.1063/1.2733026
11
C Jensen, R Raspet. Thermoacoustic power conversion using a piezoelectric transducer. Journal of the Acoustical Society of America, 2010, 128(1): 98–103 https://doi.org/10.1121/1.3409370
12
J Smoker, M Nouh, O Aldraihem, A Baz. Energy harvesting from a standing wave thermoacoustic-piezoelectric resonator. Journal of Applied Physics, 2012, 111(10): 104901 https://doi.org/10.1063/1.4712630
13
K Luo, D M Sun, J Zhang, N Zhang, K Wang, Y Xu, J Zou. Operating characteristics of crank-rod transducers used in thermoacoustic power generation. Journal of Zhejiang University (Engineering Science), 2017, 51(8): 1619–1625 (in Chinese)
14
K Luo, N Zhang, J Zhang, D M Sun, K Wang, Y Xu, J Zou. Study on impedance characteristics of crank-rod transducer used in thermoacoustic power generation system. Journal of Engineering Thermophysics, 2017, 38(11): 11–17 (in Chinese)
15
A F Falcão, J C Henriques. Oscillating-water-column wave energy converters and air turbines: a review. Renewable Energy, 2016, 85: 1391–1424 https://doi.org/10.1016/j.renene.2015.07.086
Y Luo, A Presas, Z Wang. Numerical analysis of the influence of design parameters on the efficiency of an OWC axial impulse turbine for wave energy conversion. Energies, 2019, 12(5): 939 https://doi.org/10.3390/en12050939
18
J P Clark, W C Ward, G W Swift. Design environment for low-amplitude thermoacoustic energy conversion (DeltaEC). Journal of the Acoustical Society of America, 2007, 122(5): 3014 https://doi.org/10.1121/1.2942768
19
D Kees, O Pawel, X Maurice. Bi-directional turbines for converting acoustic wave power into electricity. In: Proceedings of the 9th PAMIR International Conference. Riga, LV, USA, 2014
20
K Kaneuchi, K Nishimura. Evaluation of bi-directional turbines using the two-sensor method. In: Proceedings of the 3rd International Workshop on Thermoacoustics. Enschede, the Netherlands, 2015
21
C Zwikker, C. Kosten Sound Absorbing Materials. New York: Elsevier Publisher, 1949
22
G W Swift, S L Garrett. Thermoacoustics: a unifying perspective for some engines and refrigerators. Journal of the Acoustical Society of America, 2003, 113(5): 2379–2381 https://doi.org/10.1121/1.1561492
23
W P Arnott, H E Bass, R Raspet. General formulation of thermoacoustics for stacks having arbitrarily shaped pore cross sections. Journal of the Acoustical Society of America, 1991, 90(6): 3228–3237 https://doi.org/10.1121/1.401432
24
Y Y Chen, E C Luo, W Dai, J G Weisend, J Barclay, S Breon, J Demko, M DiPirro, J P Kelley, P Kittel, A Klebaner, A Zeller, M Zagarola, S Van Sciver, A Rowe, J Pfotenhauer, T Peterson, J Lock. New model and measurement principle of flowing and heat transfer characteristics of regenerator. AIP Conference Proceedings, 2008, 985: 251–258 https://doi.org/10.1063/1.2908554
25
D. Ma General theory and design of microperforated-panel absorbers. Journal of Functional Materials, 1997, 28(5):385–393
26
A Thakker, P Frawley, H Khaleeqk, Y Abugihalia. Experimental and CFD analysis of 0.6 m impulse turbine with fixed guide vanes. In: Proceedings of the 11th International Offshore and Polar Engineering Conference. Stavanger, Norway, 2001, 625–629
27
M Iguchi, M Ohmi, K Maegawa. Analysis of free oscillating flow in a U-shaped tube. Bulletin of the JSME—Japan Society of Mechanical Engineers, 1982, 25(207): 1398–1405 https://doi.org/10.1299/jsme1958.25.1398
28
P Yang, H Chen, Y Liu. Numerical investigation on nonlinear effect and vortex formation of oscillatory flow throughout a short tube in a thermoacoustic Stirling engine. Journal of Applied Physics, 2017, 121(21): 214902 https://doi.org/10.1063/1.4984795
29
D D Liu, Y Y Chen, W Dai, E C Luo. Design and numeric simulation of a thermoacoustic bi-directional turbine test rig. In: Proceedings of the ASME Turbo Expo: Turbomachinery Technical Conference and Exposition. Phoenix, AZ, USA, 2019, V02CT41A039
